Contents 1 Important Safety Notice 2 Your Docking Speaker Introduction What's in the box Overview of the main unit 3 Get started Connect power Turn on 4 Play Play audio from iPod/ iPhone/ iPad Play through an audio cable Other features Update the firmware 5 Product information Specifications...
Please visit www.recycle.philips.com for fallen into the device, the device has been additional information on a recycling center in exposed to rain or moisture, does not your area.
Page 5
The making of unauthorized copies of copy- protected material, including computer programs, files, broadcasts and sound recordings, may be an infringement of copyrights and constitute a criminal offence. This equipment should not be used for such purposes. “Made for iPod, ” “Made for iPhone, ” and “Made for iPad”...
2 Your Docking Overview of the main unit Speaker Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With DS1600, you can: • enjoy audio from your iPod/iPhone/iPad;...
Page 7
h Display panel • Adjust volume. j Toggle switch for lightning/30-pin control • Adjust brightness of display and bottom light.
3 Get started Switch to standby mode DS1600 switches to standby mode in the following situations: Always follow the instructions in this chapter in • In dock mode: no audio signal from the sequence. docked iPod/iPhone/iPad over 15 minutes. In AUDIO IN mode: no audio signal •...
4 Play Switch the dock Switch the dock between the lightning connector and 30-pin connector for different generation of Apple device. Slide the switch to the right. Play audio from iPod/ iPhone/ » The dock swivels and the alternate iPad connector is accessible.
When using DS1600 for the first time, a Listen to the iPod/ iPhone/ iPad required software application automatically pops up. Note • Make sure that the iPod/ iPhone/ iPad is loaded correctly. • Start music play in your iPod/ iPhone/ iPad. »...
To set time format: Charge your mobile phone In standby mode, press TIME/DATE to Charge your mobile phone through the USB display time. socket in DS1600 with a USB cable (not Press and hold TIME/DATE for 2 seconds supplied). to select 12 or 24 hour format. Press TIME/DATE to confirm.
Adjust brightness • Press repeatedly to select different levels of display light. • Press and hold to turn on or off the bottom light. 3 sec Follow onscreen instructions to complete firmware updating. Note Update the firmware • During the firmware updating, keep the iPod/ iPhone/ iPad powered on and docked on DS1600.
5 Product General information information AC/DC switching Model: AS250-050- AB400 adapter Input: 100-240 V~, 50/60 Hz, 1.2 A Output: 5 V 4 A; Note Model: MSP -C4000IC5.0 • Product information is subject to change without prior -24M-CN notice. Input: 100-240 V~, 50/60 Hz, 0.6A MAX.
If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Web page (www.philips. com/support). When you contact the Consumer Care, make sure that the product is nearby and the model number and serial number are available.