Sealey Premier CST990HD Quick Start Manual

thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear safety
instructions footwear
1. Safety
Always load evenly with the centre of gravity of the load as near the centre and
9
rear of the plate as possible.
obtain additional support for large or wide loads to prevent tipping.
9
Do not overload the truck - see Specification.
8
Do not leave unattended, especially when loaded, unless the wheels are
8
chocked or the truck is otherwise secured.
Do not use truck on uneven ground and do not run over curbs or steps - use a
8
ramp.
Do not allow others to ride on the truck.
8
Do not use the truck if any part is damaged, paying particular attention to the
8
wheels.
2. introDuction
Heavy-duty tubular steel construction with welded joints with 300kg capacity. Puncture proof
heavy-duty PU tyres with powder coated steel hubs. Features foldaway toe plate for added
extension when transporting larger loads. Three year warranty.
3. SPecification
Model no: ............................................................ CST990Hd
Capacity: ...................................................................... 300kg
Height(s): ................................................................. 1220mm
nett Weight: ................................................................ 14.6kg
overall Width: ............................................................ 580mm
Platform depth: .......................................................... 300mm
Wheel Bore Size: ...................................................... Ø20mm
Wheel Size: ............................................................. Ø250mm
Wheel Width:................................................................ 85mm
4. aSSeMbly
4.1. Wheels. ensure each axle is clean from dust and dirt to allow free movement of
the wheel. You will need to slide the axle through the frame bushes first.
4.2. Slide the wheel (fig.2.2) onto the axle (fig.2.1), followed by the washer (fig.2.3)
and complete by pushing the split pin (fig.2.4) through the hole in the end of the
axle and bending over to retain.
4.3. Repeat for the other side.
© Jack Sealey limited
Heavy-Duty Sack truck witH Pu tyreS
300kg caPacity
cSt990HD
Model no:
Original Language Version
fig.1
fig.2
CST990Hd Issue 1 16/05/19