Table of Contents
Advertisement
If Optimize Standby is switched on
(see "Programming options, Optimize
Standby"), the time display will go out
after a few minutes following activa-
tion of delay start time, leaving just the
Start indicator light flashing slowly.
Press any button to switch the display
back on again for a few minutes.
The time up until the program starts will
count down in the display in hours for
durations above 10 hours, and in min-
utes for durations below 10 hours.
When the set time is reached, the pro-
gram selected will start automatically.
The time remaining will appear in the
time display and the indicator light
will go out.
How the Delay Start time is shown in
the display:
up to 59 minutes:
e.g., 30 minutes = .
1 hour up to 9 hours 30 minutes:
e.g., 5 hours = .
over 10 hours:
e.g., 15 hours =
If you open the door during the delay
start time, you must then press the
Start button to continue the delay start
time.
Starting a program before the delay
start time has elapsed:
A program can be started before the
delay start period has elapsed.
Proceed as follows:
Turn the dishwasher off with the
button.
Turn the dishwasher on again with the
button.
Select the program you want.
Press the Start button.
The program cycle will begin. The Start
indicator light will come on.
Options
45
Advertisement
Table of Contents
