Advertisement
Available languages
Available languages
Setting up the headset
Before you can use your
Bluetooth headset, you need to:
• charge the headset and
• register the headset with the
mobile phone.
Charging the Bluetooth
headset
The battery supplied has not
been fully charged.
To charge the headset, you will
need the charging unit included
in the delivery. Please note that
the mains power socket must be
nearby and easily accessible.
You can also charge the Headset
with a Travel Charger
ETC-500/510* or Car Charger
Plus ECC-600* using the
charging adapter ECA-500*.
*: These products are offered as
original accessories.
Headset PTT Bluetooth
1. Insert the charging unit
connector
headset
diagram.
2. Plug the charging unit plug
into the socket.
Charge time
A flat battery takes about two
and a half hours to fully charge.
Display during charging
The LED is red during charging.
When the battery is fully
charged, the LED turns off.
Only charge the battery at a tempera-
ture of 0 °C to 45 °C. Otherwise, it will
wear out prematurely. Please note
that batteries generally wear out over
time.
Switching on the Bluetooth
Headset
Press the ptt button for
3 seconds. The LED flashes
rapidly for 1 second, then it
flashes more slowly. A low and a
high tone can be heard.
Switching off the Bluetooth
Headset
Press the ptt button for
3 seconds. The LED lights up
steadily for 1 second and then
goes out. A high and a low tone
can be heard.
®
(en)
into the
as shown in the
7
Advertisement
