Using An Ethernet Cable - D-Link COVR-C1202 User Manual

Section 4 - Adding Additional Covr Points

Using an Ethernet Cable

Refer to the steps below to learn how to add more Covr Points to your Covr network using an Ethernet cable.
Step 1
Use the Ethernet cable to connect the new Covr Point to an existing
A
Covr Point.
Step 2
Connect the Covr Points to a power source. When the Covr LED on the
A
new Covr Point changes from blinking orange to solid white, the new
Covr Point is paired and will reboot itself to complete the setup process.
Step 3
Disconnect the Ethernet cable and place the new Covr Point anywhere
in your home to extend your whole home Wi-Fi.
D-Link COVR-C1202 User Manual 70