Philips 32BDL3550Q User Manual page 6

32BDL3550Q
Electric, Magnetic and Electronmagnetic
Fields ("EMF")
1. We manufacture and sell many products targeted
at consumers, which, like any electronic apparatus,
in general have the ability to emit and receive
electromagnetic signals.
2. One of our leading Business Principles is to take all
necessary health and safety measures for our products,
to comply with all applicable legal requirements and
to stay well within the EMF standards applicable at the
time of producing the products.
3. We are committed to develop, produce and market
products that cause no adverse health effects.
4. We confirm that if its products are handled properly for
their intended use, they are safe to use according to
scientific evidence available today.
5. We play an active role in the development of
international EMF and safety standards, enabling us to
anticipate further developments in standardization for
early integration in its products.
Information for U.K. only
WARNING – THIS APPLIANCE MUST BE EARTHED.
Important:
(B)
(A)
This apparatus is supplied with an approved moulded
13A plug. To change a fuse in this type of plug proceed as
follows:
1. Remove fuse cover and fuse.
2. Fit new fuse which should be a BS 1362 5A,A.S.T.A. or BSI
approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it
should be cut off and an appropriate 3-pin plug fitted in its
place.
If the mains plug contains a fuse, this should have a value
of 5A. If a plug without a fuse is used, the fuse at the
distribution board should not be greater than 5A.
NOTE:
The severed plug must be destroyed to avoid a
possible shock hazard should it be inserted into a
13A socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured in accordance with
the following code:
BLUE – "NEUTRAL" ("N")
BROWN – "LIVE" ("L")
GREEN & YELLOW – "EARTH" ("E")
1. The GREEN & YELLOW wire must be connected to the
terminal in the plug which is marked with the letter "E"
or by the Earth symbol or coloured GREEN or GREEN &
YELLOW.
2. The BLUE wire must be connected to the terminal which
is marked with the letter "N" or coloured BLACK.
3. The BROWN wire must be connected to the terminal
which marked with the letter "L" or coloured RED.
Before replacing the plug cover, make certain that the cord
grip is clamped over the sheath of the lead – not simply
over the three wires.
vi