English MITRE SAW DCS781 You have chosen a D WALT tool. Years of experience, thorough product development and These products also comply with Directive, 2014/53/EU; 2014/30/EU and 2011/65/EU. For innovation make D WALT one of the most reliable partners for professional power tool users.
English Bent or warped workpieces can twist or shift and may cause binding on the spinning saw • SECURE THE MACHINE TO A STABLE SUPPORTING SURFACE. Vibration can possibly blade while cutting. There should be no nails or foreign objects in the workpiece. cause the machine to slide, walk, or tip over, causing serious injury.
English • Risk of injury when changing the blade. • Disconnect the charger from the outlet before attempting any cleaning. This will reduce the risk of electric shock. Removing the battery pack will not reduce this risk. • Risk of squeezing fingers when opening the guards. •...
Class 9 Hazardous Material. In general, only shipments containing a lithium‑ion battery with an energy rating greater than 100 Watt Hours (Wh) will require being shipped The DCS781 operates on a 54 volt battery pack. as fully regulated Class 9. All lithium‑ion batteries have the Watt Hour rating marked on the These battery packs may be used: DCB546, DCB547, DCB548.
English To cut through an existing pencil line on a piece of wood, turn on the CUTLINE™ worklight using the momentary switch 21 (not with the main trigger), then pull down on the operating Keep hands away from blade. handle 2 to bring the saw blade close to the wood.
English Installing a Blade (Fig. A, G) the normal limit, then tighten the fence adjustment knobs to keep the fences in this location. When using this feature, make a dry cut first to ensure the blade does not contact the fences. 1. Remove battery pack from the saw.
English Installing and Removing the Battery Pack (Fig. A) bevel pawl, remove the retaining screw, the 22.5 ° bevel pawl and the 30 ° crown bevel pawl. Flip the crown bevel pawl so the 33.9 ° is facing up. Reattach the screw to secure the 22.5 ° WARNING: Ensure the tool/appliance is in the off position before inserting the bevel pawl and the crown bevel pawl.
Page 17
D WALT service center. nOTE: To provide greater crosscut capacity with reduced stroke, the blade on the DCS781 Other aids such as spring clamps, bar clamps or C‑clamps may be appropriate for certain sizes extends deeper into the table.
English Example: To make a 4‑sided box with 26 ° exterior angles (Angle A, Fig. S), use the upper right When setting bevel and mitre angles for all compound mitres, remember that: arc. Find 26 ° on the arc scale. Follow the horizontal intersecting line to either side to get mitre The angles presented for crown moldings are very precise and difficult to set exactly.
English Optional Accessories WARNING: Since accessories, other than those offered by D WALT, have not been tested Lubrication with this product, use of such accessories with this tool could be hazardous. To reduce the Your power tool requires no additional lubrication. risk of injury, only D WALT, recommended accessories should be used with this product.
Page 20
Belgique et WALT - Belgium BVBA Tel: NL 32 15 47 37 63 www.dewalt.be Egide Walschaertsstraat 16 Luxembourg België en Luxemburg Tel: FR 32 15 47 37 64 enduser.BE@SBDinc.com 2800 Mechelen Fax: 32 15 47 37 99 Danmark WALT (S &D...