NEC MultiSync X464UNV-3 User Manual page 30

TERMINAL SETTING
DVI MODE
D-SUB MODE
1
BNC MODE*
1
SCART MODE*
DisplayPort
HDMI SIGNAL
DEINTERLACE
ON
OFF
1
COLOR SYSTEM*
VIDEO, S-VIDEO inputs only
AUTO
NTSC
PAL
SECAM
4.43 NTSC
PAL-60
OVER SCAN
1 1 1
HDMI, Y/Pb/Pr, SCART* , VIDEO* , S-VIDEO* ,
1 1
HDMI2* , HDMI3* inputs only
ON
OFF
OPTION SETTING
OPTION POWER
AUDIO* 1
1
INTERNAL PC*
OFF WARNING
AUTO OFF
START UP PC
FORCE QUIT
*1: This function depends on which option board you use.
*2: Multi-Stream Transport requires the corresponding display card. Contact your dealer for limitations of this function.
Selects the kind of DVI-D equipment which is connected to the DVI input.
Select "DVI-HD" when DVD player or computer equipment, which requires HDCP authentication,
is connected.
Select "DVI-PC" when a computer equipment, which not requires HDCP authentication, is
connected.
Selects the type of signal associated with the D-SUB input.
RGB: Analog input (R, G, B, H, V)
COMPONENT: Component (Y, Cb/Pb, Cr/Pr)
Selects the kind of equipment which is connected to the BNC input.
RGB: Analog input.
COMPONENT: Component.
Input mode for devices using SCART connectors.
Selects DisplayPort mode [1.1a] or [1.2].
[1.2] should be selected when using Multi-Stream Transport.*
RAW: Disable the expanded feature.
EXPAND: Expand image contrast and increase detail in the dark and bright areas.
Selects the IP (Interlace to Progressive) conversion function.
NOTE: For DVI input "DVI-HD" needs to be enabled in the DVI mode menu. When INPUT2 of
SUPER is selected in INPUT CHANGE and displayed, this function cannot be changed.
Converts interlaced signals to progressive. This is the default setting.
Disables IP conversion. This setting is best suited for motion pictures, but increases the risk of
image retention.
The selected Color System depends on the video format of the input signal.
Automatically chooses Color System setting based on input signal.
Some video formats may require different scanning modes in order to best display the image.
Image size is larger than what can be displayed. The image edge will appear cropped.
Approximately 95% of the image will be shown on the screen.
Image size stays within the display area. The whole image is displayed on the screen.
NOTE: When you use a computer with HDMI out, please set "OFF".
Allow the monitor to supply power to Option board slot during power save mode or standby
mode.
NOTE: This function should be set to ON when using power save management by slot 2 type
option.
Selects sound input signal according to slot2 type option's specifi cations. To activate DIGITAL,
select OPTION for input signal and OPTION for AUDIO INPUT.
NOTE: DIGITAL is activated only when OPTION is selected for input signal and OPTION for
AUDIO INPUT.
The function is available for slot 2 type PC.
If OPTION POWER is OFF, a warning message appears when monitor power is turned off.
NOTE: Warning message does not appear when monitor power is turned off by OFF TIMER
setting or SCHEDULE setting.
Monitor power is automatically "OFF" when connected PC is OFF or the monitor is in power save
mode.
NOTE: Monitor power is not automatically "ON" when connected PC is ON.
When ON is selected, connected PC start-up.
When ON is selected, it performs force-quit PC.
Please use this function only when the operating system cannot be shut down manually.
2
English-28
DVI-HD
RGB
RGB
OFF
1.1a
Depends on
signal input
ON
AUTO
ON
-
OFF
ANALOG
OFF
OFF
NO
NO