Table of Contents
Advertisement
ENGLISH
72
Machine actions
The machine does not turn
on.
The machine is in demo
mode.
The drip tray gets fi lled al-
though no water is drained.
The red
icon is always
displayed on the machine.
The brew group cannot be
removed.
The brew group cannot be
inserted.
Coff ee is not hot enough.
Causes
The machine is not connected to
the electric network, or the power
button is in the "O" position.
The "
" button was pressed and
held for more than 8 seconds.
Water is sometimes drained auto-
matically by the machine into the
drip tray to manage the rinsing of
the circuits and ensure optimum
machine performance.
The coff ee grounds drawer has
been emptied with the machine
off .
The coff ee grounds drawer has
been emptied with the machine
on without waiting at least 5 sec-
onds before reinserting it.
The brew group is out of place.
The coff ee grounds drawer is
inserted.
The brew group is not in the off
position.
The gearmotor is not in the correct
position.
The cups are cold.
The temperature is not correctly
set.
Solutions
Connect the machine to the electric
network and turn the power button
to the "I" position.
Turn the machine off and back on
using the power button.
This is a normal behaviour of the
machine.
The coff ee grounds drawer must
always be emptied with the machine
on. Wait until the
icon is dis-
played before refi tting the drawer.
Wait until the
icon is displayed
before refi tting the drawer.
Turn on the machine. Close the ser-
vice door. The brew group automati-
cally returns to the initial position.
Remove the coff ee grounds drawer
before removing the brew group.
Make sure that the brew group in
the off position, as described in the
"Weekly Cleaning of the Brew Group"
chapter.
Insert the drip tray and the coff ee
grounds drawer. Close the service
door. Turn on the machine with-
out inserting the brew group. The
gearmotor moves back to the correct
position. Turn off the machine and
reinsert the brew group as described
in the "Weekly Cleaning of the Brew
Group" chapter.
Preheat the cups with hot water.
Set the temperature as described in
the "Programming" chapter.
Advertisement
Table of Contents
