Before Washing For The First Time; Transportation - Bosch WAK24260ID Instruction Manual And Installation Instructions

Positioning and connecting
en
Do not use the machine with an
■
extension box, extension cord, spike
busters etc., as this may lead to
improper grounding conditions.
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle without any laundry.
Notes
The washing machine must be
■
correctly installed and connected
~ Page 32
Never use a damaged machine.
■
Inform your after-sales service.
~ Page 30
Check the machine.
1.
Remove the protective film from the
2.
control panel.
Connect the mains plug.
3.
Turn on the water tap.
4.
Close the washing machine door (do
5.
not load any laundry).
Select the l Drum Clean
6.
programme.
Open the detergent drawer.
7.
Pour approx. 1 litre of water into
8.
compartment II.
Pour standard detergent into
9.
compartment II.
To prevent foaming, only use
Note:
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
for wool or delicates.
Close the detergent drawer.
10.
Press Start/Reload A .
11.
Switch off the appliance at the end of
12.
the programme.
Your washing machine is now ready to
use.
38

Transportation

e.g. when moving home
Preparatory work:
Turn off the water tap.
1.
Reduce the water pressure in the
2.
supply hose.
Maintenance – filter in the water
supply ~ Page 25
Drain the remaining detergent
3.
solution.
Maintenance – detergent solution
pump blocked ~ Page 24
Disconnect the washing machine
4.
from the mains.
Remove the hoses.
5.
Before initial use:
Notes
The transport locks must be
■
removed. ~ Page 34
To prevent unused detergent from
■
flowing straight into the drain during
the next wash: Pour
approximately 1 litre of water into
compartment II and select and start
the 0 Spin/Drain [ programme (if
only drain cycle is required, set
rpm 0 on - - - ).
Installing the transport locks:
Remove the covers and keep them
1.
in a safe place.
Use a screwdriver if necessary.