Table of Contents
Advertisement
13.5.1 Cleaning dirty filters
• Temperature of the water inside the product may rise up
to 90 ºC. To avoid the risk of scalding, clean the filter after
the water inside the product has cooled down.
CAUTION!
Open the filter cap.
- Pull the emergency draining hose out from its seat.
- Place a large container at the end of the hose. Drain the
- When draining of water is finished, close the end by the
- Turn the pump filter to take it out.
Washing Machine / User's Manual
a) Unplug the product.
b) Open the filter cap.
c) Proceed as follows for draining water.
water into the container by pulling out the plug at the
end of the hose. When the container is full, block the inlet
of the hose by replacing the plug. After the container is
emptied, repeat the above procedure to drain the water
in the product completely.
plug again and fix the hose in its place.
d) Clean any residues inside the filter as well as fibers, if any, around
the pump impeller region.
e) Install the filter.
f) Close the filter cover.
EN / 49
Advertisement
Table of Contents
