Electrolux E786W303BI User Manual page 34

34 www.electrolux.com
After touching the Start/Pause
the maximum declared load indicator
goes off, the SensiCare System starts
the laundry load detection:
1. The appliance detects the load in the
first 30 seconds. During this phase
the Time Manager bars
below the time digits play a simple
animation, the drum rotates shortly.
2. The programme duration will be
adjusted accordingly and could
increase or decrease. After further 30
seconds, the water filling starts.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pause
the programme again. The SensiCare
phase can be repeated up to three times
(see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The SensiCare detection is
carried out with complete
washing programmes only
and if the programme
duration has not been
reduced by means of the
Time Manager button.
10.9 Interrupting a programme
and changing the options
When the programme is running, you
can change only some options:
1. Touch the Start/Pause
button,
placed
is
button to start
button.
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the button Start/Pause
again.
The washing programme continues.
10.10 Cancelling a running
programme
1. Press the button On/Off to cancel the
programme and to deactivate the
appliance.
2. Press the button On/Off again to
activate the appliance.
If the SensiCare System has
completed and the water
filling has already started,
the new programme starts
without repeating the
SensiCare System. The
water and the detergent are
not drained out in order to
avoid waste. The display
shows the maximum
duration of the programme,
updating it about 20 minutes
after the starting of the new
programme.
There is also an alternative way of
cancelling:
1. Rotate the selector knob to the "Reset"
position .
2. Wait for 1 second. The display shows
.
Now, you can set a new washing
programme.
10.11 Opening the door -
Adding garments
If the temperature and level
of the water in the drum are
too high and/or the drum is
still rotating you should not
open the door.
While a programme or the delay start
operates, the appliance door is locked.
The display shows the indicator .