Siemens FI18 Series Instructions For Use Manual page 19

Hide thumbs Also See for FI18 Series:
Table of Contents

Advertisement

Fault
The ice maker does not make
any ice.
Ice forms in the inflow hose to
the ice maker.
Water runs from the appliance. The water connection hose is not
The water pressure is less than
usual.
Possible cause
The ice maker is switched off.
The appliance is not supplied with
water.
Water supply has kinks.
Low water pressure.
Temperature in the freezer space is
too warm.
Ice cube container is not properly
inserted.
Incorrect shut-off tap installed.
Ice maker sensor is blocked.
Low water pressure.
Shut off tap incorrectly opened.
Temperature in the freezer space is
too warm.
properly sealed.
Incorrect shut-off tap installed.
Low water pressure.
Shut off tap incorrectly opened.
Incorrect shut-off tap installed.
Water supply has kinks.
The water filter is bunged up or used. Change the water filter.
Remedial action
Switch the ice maker on at the control panel.
Contact the installer or the water supply
company.
Turn off the water supply at the shut-off tap.
Smoothen out the kinks, exchange where
necessary.
Connect the appliance to the stipulated
water pressure only (see chapter
Connecting appliance, section Water
connection).
Check freezer compartment temperature
and, if required, set slightly colder.
Check the position, re-insert where
necessary.
Incorrect taps can cause low water pressure
and damage to the appliance.
Pull out and empty ice cube container.
Remove ice from the sensor.
Connect the appliance to the stipulated
water pressure only (see chapter
Connecting appliance, section Water
connection).
Open shut off tap fully.
Set temperature slightly colder in the freezer
compartment.
Replace the hose with a manufacturer's
original part.
Incorrect taps can cause low water pressure
and damage to the appliance.
Connect the appliance to the stipulated
water pressure only (see chapter
Connecting appliance, section Water
connection).
Open shut off tap fully and check for leaks.
Check the minimum through flow.
Incorrect taps can cause low water pressure
and damage to the appliance.
Turn off the water supply at the shut-off tap.
Smoothen out the kinks, exchange where
necessary.
en
19

Advertisement

Table of Contents
loading

Table of Contents