Mounting On A Table; Tidying Cables - LG 42LM5800 Owner's Manual

Mounting on a table

1
Lift and tilt the TV into its upright position on a
table.
- Leave a 10 cm (4 inch) (minimum) space from
the wall for proper ventilation.
10 cm
2
Connect the power cord to a wall outlet.
CAUTION
Do not place the TV near or on sources
y
of heat, as this may result in fire or other
damage.
Securing the TV to a table
(For 47LM4600, 32/42/47LM5800)
Fix the TV to a table to prevent from tilting
forward, damage, and potential injury.
Mount the TV on a table, and then insert and
tighten the supplied screw on the rear of the
stand.
WARNING
To prevent TV from falling over, the TV
y
should be securely attached to the floor/
wall per installation instructions. Tipping,
shaking, or rocking the TV may cause injury.
(4 inches)
10 cm
1 0 c m
10 cm
ASSEMBLING AND PREPARING
Adjusting the angle of the TV to suit view
Swivel 20±2 degrees to the left or right and adjust
the angle of the TV to suit your view.
20 2
CAUTION
When adjusting the angle of the TV,
y
watch out for your fingers.
- Personal injury may occur if hands or
fingers are pinched. If the product is
tilted too much, it may fall, causing
damage or injury.

Tidying cables

1
Gather and bind the cables with the cable
holder.
CAUTION
Do not move the TV by holding the cable
y
holder and power cord holder, as the cable
holders may break, and injuries and damage
to the TV may occur.
17
20 2
Cable holder