Table of Contents
Advertisement
5Installation
P reparing for installation
I n s t a l l a t i o n
Caution!
Ensure that there are no electrical wires, gas pipes or
water pipes in the area where holes are to be drilled.
Cover the hob to protect it from damage.
1.
Mark where the centre of the extractor hood should
2.
be on the ceiling above the centre of the hob.
Using the template provided, mark the locations
3.
where the bolts should be inserted on the ceiling.
Drill four 8 mm diameter holes to a depth of 80 mm
4.
for fastening the appliance and press in the wall
plugs flush with the wall.
Preparing the appliance
Screw in the four bolts on the edge of the frame at
1.
the marked locations, leaving them protruding out of
the frame by approx. 5 mm.
Remove the film from the frame cover.
2.
Remove the activated charcoal filter from the film.
3.
Open the cover on the top of the appliance and
4.
remove it
, insert the activated charcoal filter
¨
and then close the cover.
min. 5 mm
©
Fitting the frame
Screw in the two bolts, leaving them protruding out
1.
of the ceiling by 5 - 9 mm
Make sure that the bolts
Note:
cover
and control
ª
relative to one another. The position of the control is
marked on the template.
Installation en
.
¨
, frame
, frame
¨
©
are positioned correctly
«
13
Advertisement
Table of Contents
