Table of Contents
Advertisement
NOTE:
This unit can be used only where the power supply is
AC 220–240V ~ ± 10%, 50Hz ± 0.5%. It cannot be used
elsewhere.
CAUTION:
USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
AS THE LASER BEAM USED IN THIS UNIT IS
HARMFUL TO THE EYES, DO NOT ATTEMPT TO
DISASSEMBLE THE CABINET. REFER SERVICING TO
QUALIFIED PERSONNEL ONLY.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR
MOISTURE.
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, AND ANNOYING INTERFERENCE, USE THE
RECOMMENDED ACCESSORIES ONLY.
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE THIS APPARATUS TO DRIPPING OR
SPLASHING, NO OBJECTS FILLED WITH LIQUIDS,
SUCH AS VASES, SHOULD BE PLACED ON THE
APPARATUS.
Laser Diode Properties
Material:
Wave length:
Emission Duration:
Laser output:
• This unit is classified as a CLASS 1 LASER product.
• The CLASS 1 LASER PRODUCT marking is embossed on
the rear cover.
• This product contains a low
power laser device. To ensure
continued safety, do not
remove any cover or attempt
to gain access to the inside of
the product. Refer all
servicing to qualified
personnel.
Supplied Accessory
• Remote control
with two R6 (AA) size
batteries
• Operation Manual
For Customer Use:
Read carefully the information located at the bottom
of your unit and enter below the Serial No. Retain this
information for future reference.
Model No.: VCR/DVD RECORDER COMBINATION: DV-RW360H
Serial No.: __________________________________
2
EN
Downloaded from:
http://www.usersmanualguide.com/
Before you start
GaAs
DVD: 658 nm
CD:
790 nm
Continuous
Max. 19 mW
CLASS 1 LASER PRODUCT
CLASSE 1 PRODUIT LASER
PRODUCT CON LASER CLASE 1
DVD/VCR
AV2 (DECODER)
AV1 (TV)
• Round Coaxial cable
• Quick Start Guide
Quick Start Guide for DV-RW360H
Accessories
How to install the batter-
Connection
Precautions
Power Cord Protection
To avoid any malfunctions of the unit, and to protect
against electric shock, fire or personal injury, please
observe the following.
• Hold the plug firmly when connecting or disconnecting
the AC power cord.
• Keep the AC power cord away from heating appliances.
• Never put any heavy object on the AC power cord.
• Do not bundle any cables such as; AC power cord,
Round Coaxial cable or other cables that are used to
connect this unit to your TV together. Or never put
any cables on the top panel of this unit. The noise or
disturbance of the picture may be generated.
• Do not attempt to repair or reconstruct the AC power
cord in any way.
Connection to Power
SPECIAL NOTE FOR USERS IN THE U.K.
The mains lead of this product is fitted with a non-
rewireable (moulded) plug incorporating a 3A fuse.
Should the fuse need to be replaced, a BSI or ASTA
approved BS 1362 fuse marked
rating as above, which is also indicated on the pin face of
the plug, must be used. Always refit the fuse cover after
replacing the fuse. Never use the plug without the fuse
cover fitted. In the unlikely event of the socket outlet in
your home not being compatible with the plug supplied,
cut-off the mains plug and fit an appropriate type.
DANGER: The fuse from the cut-off plug should be
removed and the cut-off plug destroyed
immediately and disposed of in a safe manner.
Under no circumstances should the cut-off
plug be inserted elsewhere into a 13A socket
outlet, as a serious electric shock may occur.
To fit an appropriate plug to the mains lead,
follow the instructions below:
IMPORTANT: The wires in
the mains lead are coloured
in accordance with the
DVD
ANTENNA
DIGITAL
AUDIO
S-VIDEO
COMPONENT
AUDIO OUT
OUT
OUT
VIDEO OUT
Y
IN
following code:
P
B
L
/C
B
COAXIAL
R
P
R
/C
R
Blue: Neutral
OUT
Brown: Live
As the colours of the wires
in the mains lead of this product may not correspond
with the coloured markings identifying the terminals in
your plug, proceed as follows:
- The wire which is coloured blue must be connected to
the plug terminal which is marked N or coloured black.
- The wire which is coloured brown must be connected
to the plug terminal which is marked L or coloured red.
Ensure that neither the brown nor the blue wire is
connected to the earth terminal in your three-pin plug.
Before replacing the plug cover make sure that:
- If the new fitted plug contains a fuse, its value is the
same as that removed from the cut-off plug.
- The cord grip is clamped over the sheath of the mains
lead and not simply over the lead wires.
IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED
ELECTRICIAN.
Note: A 5A fuse is also acceptable for a non-rewireable
(moulded) plug which is used for this product.
or
and of the same
ASA
FUSE
BROWN
(Live)
BLUE
(Neutral)
CORD GRIP
OUTER SHEATH OF THE WIRE
Advertisement
Table of Contents
