Before using for the first time
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage is set in stages
from 0 to 6. It is set to 3 at the factory.
This is the recommended setting.
If the "Adjust Automatic" programme
function (depending on model) has
been activated, the amount of rinse aid
dispensed in the Automatic programme
can be higher than that set.
If spots appear on crockery and glass-
ware:
Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
Decrease the rinse aid dosage.
28
Switch the dishwasher off with the
button, if it is switched on.
Press the / button in and whilst
holding it in switch the dishwasher
on using the button.
Keep the / button pressed in for
at least four seconds until the /
indicator light comes on.
If this does not happen, start the pro-
cedure from the beginning again.
Press the button 3 times.
The indicator will flash rapidly 3
times at intervals.
The dosage set will show in the display
after the symbol.
The flashing sequence will appear in
the display.
This indicates the factory default setting
3.
Use the / button to select the
setting required.
Each press on the button moves you
up a level. After reaching the highest
value the counter starts from the be-
ginning again.
The setting is now stored in memory.
Switch the dishwasher off with the
button.