What You Need; The 3D Glasses - Philips 6100 Series User Manual

12
3D
12.1

What you need

This is an Active 3D TV. On this TV, you can watch 3D
programs and movies in full High Definition resolution
with Active 3D.
To watch 3D you need to :
• Tune to a TV channel that broadcasts programs in
3D
• Rent a movie in 3D from an online video store with
Smart TV
• Watch a movie in 3D from a 3D Blu-ray Disc, a USB
device, or computer
To also watch in 3D on this TV, you will need one of
these types of Philips Active 3D glasses. . .
• PTA507
• PTA508
• PTA509
• PTA517
• PTA518
• PTA519
All types are sold separately. Other active 3D glasses
might not be supported.
12.2

The 3D glasses

Overview
1 - On or off switch
2 - Player 1 or player 2 selection
3 - Receiver lens
4 - Battery compartment
When you unpack the 3D glasses, also remove the
small plastic foil from the battery compartment that
prevents the battery from running empty.
Turn on and off
Turn on
When a 3D program is shown on screen, press  on
the 3D glasses and put them on. The glasses need
some seconds to adjust to the 3D signal from the 3D
transmitter on the TV. At first use, this may take up to
15 seconds.
Battery level
You can check the battery level when you turn on the
3D glasses.
• If the LED light blinks green, you can use the glasses
for 4 hours or more.
• If the LED light blinks orange, you can use the
glasses for at least 2 hours but less than 4.
• If the LED light blinks red, the battery is almost
empty and less than 2 hours of 3D watching remain.
Turn off
To turn off the 3D glasses, press  . The LED light
blinks red 4 times. When the 3D glasses do not
receive 3D signals for 2 minutes, the glasses turn off
automatically.
3D transmitter
Make sure the receiver lens in the center of the
glasses can receive the 3D signals. Also, clear objects
away from the 3D transmitter on the TV.
1 - 3D transmitter on the TV
2 - 3D receiver on the 3D glasses
Two-player gaming
You can use these glasses to play two-player games.
Two players can watch the same TV but see two
different screens to play a game.
To switch the glasses to watch the Player 1 or Player 2
screen, turn on the glasses and then press the Player
1/2 key.
• If the LED light is orange and is lit up continuously
for 2 seconds, the glasses are set for player 1.
• If the LED light is orange and blinks, the glasses are
set for player 2.
For more information, press
up Two-player gaming.
Replacing the batteries
To replace the battery of the 3D glasses PTA508,
unscrew the small battery lid and replace the battery:
type CR2032 (3V). Make sure the + side of the battery
is visible. Replace the lid and fix it with the screw.
To replace the battery in the PTA509 or PTA519 3D
glasses, press the small knob on the battery lid and
slide the lid up to open. Replace the battery with a
type CR2032 (3 V) replacement. Make sure the + side
of the battery is visible. Replace the lid and slide it
down until it clicks.
 Warning
Danger of explosion if the battery is incorrectly
replaced. Replace only with the same or equivalent
type.
33

Keywords and look