Table of Contents
Advertisement
Fitting the appliance
Hook the appliance from below into the support
1.
frame.
Ensure that the mains cable is not trapped.
Note:
Fasten the appliance to the support frame using 2
2.
securing screws.
Hook in the retaining clip and screw tight.
3.
Connecting the pipes
If using an aluminium pipe, smooth the
Note:
connection area beforehand.
Exhaust-air pipe Ø 150 mm (recommended size)
Attach the exhaust-air pipe directly to the air-pipe
connector and seal.
Exhaust-air pipe Ø 120 mm
Attach the reducing connector directly to the air-pipe
1.
connector.
Attach the exhaust air pipe to the reducing
2.
connector.
Seal both joints appropriately.
3.
Attaching the flue duct
:
Warning – Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
Separate the flue ducts.
1.
To do this, remove the adhesive tape.
Remove the protective foil from both sides.
2.
Place both parts of the upper flue on the appliance
3.
and push together.
The slots of the upper flue must point
Note:
downwards.
Push up the upper flue part and secure with 2
4.
screws.
Insert both lower parts of the flue and push together.
5.
Installation
en
19
Advertisement
Table of Contents
