Distance From Projection Surface To Wall Plate; Installation Measurement Tables - Epson BrightLink 575Wi Installation Manual

Distance from projection surface to wall plate

The distance (c) from the projection surface to the bottom mounting holes on the wall plate is the number
given when the vertical slide is set to the base position, as shown below.
Match the notch on the wall mount to the position of the stamp on the wall plate.

Installation measurement tables

Use the following table to determine which installation measurement table to use for your projector.
The measurements may differ depending on the location where you place the
projector.
When projecting in Tele mode, the quality of the projected images may decrease.
BrightLink Pro 1450Ui/1460Ui
BrightLink 696Ui/697Ui
BrightLink Pro 1410Wi/1420Wi/1430Wi
BrightLink 475W/485W/575Wi/585Wi/595Wi/
685Wi/695Wi
BrightLink 575Wi+/585Wi+/595Wi+/675Wi+/
685Wi+/695Wi+
PowerLite 475W/485W/575W/585W/675W/
685W
BrightLink 480i
PowerLite 470/480/570/580/680
The throw distance measurements may differ slightly for the BrightLink Pro 1410Wi/
1420Wi/1430Wi, BrightLink 475W/480i/485W/575Wi/575Wi+/585Wi/585Wi+/595Wi/
595Wi+, and the PowerLite 470/475W/480/485W/570/575W/580/585W. For more
information, see the Throw Distance Calculator at www.epson.com/support (U.S.),
www.epson.ca/support (Canada), or www.epson.com/jm/support (Latin America).
Projector model
Notch on mount arm
Maximum image
size (diagonal) measurement table
100 inches
100 inches
93 inches
18
Base position
Stamp on plate
Installation
WUXGA
WXGA
XGA