Attaching Accessories To The Hand-Held Microphone (Utx-M03); Attaching Accessories To The Plug-On Transmitter (Utx-P03) - Sony UTX-B03 Operating Instructions Manual

Attaching the wind screen to the
microphone
Align and insert the microphone
into the hole in the wind screen.
Attaching a belt clip
To remove a belt clip
Insert one end of the belt
clip into one of two holes
on either side of the
transmitter, and then
insert the other end into
the hole on the other side.
Insert a pointed object, such as
a ball-point pen, between the
belt clip and the transmitter,
and pry the end of the belt clip
from the hole on the side of the
transmitter.
Attaching accessories to the hand-
held microphone (UTX-M03)
Attaching the microphone holder
Insert the base of the
microphone into the holder.
Replacing the microphone unit
Removing the microphone unit
Turn the microphone unit in the
direction of the arrow.
Attaching the microphone unit
Turn the microphone unit in the opposite direction from
when you removed it, and make sure that the unit is
securely attached to the microphone.
Attaching accessories to the plug-
on transmitter (UTX-P03)
Attaching a microphone or cable
Push the microphone or cable connector (XLR-3-12C
connector) into the audio input connector of the
UTX-P03 until it clicks into place.
Microphone or
cable connector
Attaching Accessories
17