Sony SRS-XE200 Reference Manual

Wireless Speaker
Reference Guide
SRS-XE200
©2022 Sony Corporation
Printed in China
https://www.sony.net/
English Wireless Speaker
Do not expose the unit to naked flame sources (for example, lighted candles).
Do not install the product in a confined space, such as a bookcase or built-in cabinet.
Do not expose the batteries (battery pack or batteries installed) to excessive heat, such as sunshine, fire
or the like, for a long time.
This unit has been tested and found to comply with the limits set out in the EMC regulation using a
connection cable shorter than 3 m.
The nameplate and important information concerning safety are attached in the following locations:
• the back of the cap on the rear side of the unit.
Do not dismantle, open or shred secondary cells or batteries.
Do not expose cells or batteries to heat or fire. Avoid storage in direct sunlight.
In the event of a cell leaking, do not allow the liquid to come in contact with the skin or eyes. If contact
has been made, wash the affected area with copious amounts of water and seek medical advice.
Secondary cells and batteries need to be charged before use. Always refer to the manufacturer's
instructions or product manual for proper charging instructions.
After extended periods of storage, it may be necessary to charge and discharge the cells or batteries
several times to obtain maximum performance.
Dispose of properly.
This product (including accessories) has magnet(s) which may interfere with pacemakers, programmable
shunt valves for hydrocephalus treatment, or other medical devices. Do not place this product close to
persons who use such medical devices. Consult your doctor before using this product if you use any
such medical device.
Never insert the USB plug when the main unit or charging cable is wet. If the USB plug is inserted while
the main unit or charging cable is wet, a short circuit may occur due to liquid (tap water, seawater, soft
drink, etc.) or foreign matter on the main unit or charging cable, and cause abnormal heat generation or
malfunction.
This product must be installed and operated with at least 20 cm separation between the radiating
element and the human body (excluding extremities: hands, wrists, feet and ankles).
5-037-895-42(1)
Licenses
• This product contains software that Sony uses under a licensing agreement with the owner of its
copyright. We are obligated to announce the contents of the agreement to customers under
requirement by the owner of copyright for the software. Please access the following URL and
read the contents of the license.
https://rd1.sony.net/help/speaker/sl/22/
• The software included in this product contains copyrighted software that is licensed under the
GPL/LGPL and other licenses which may require access to source code. You may find a copy of
the relevant source code as required under the GPL/LGPL (and other licenses) at the following
URL.
You may obtain the source code as required by the GPL/LGPL on a physical medium from us for a
period of three years after our last shipment of this product by applying through the form at the
following URL.
This offer is valid to anyone in receipt of this information.
https://oss.sony.net/Products/Linux/
Please note that Sony cannot answer or respond to any inquiries regarding the content of this
source code.
• Use of the Made for Apple badge means that an accessory has been designed to connect
specifically to the Apple product(s) identified in the badge, and has been certified by the
developer to meet Apple performance standards. Apple is not responsible for the operation of
this device or its compliance with safety and regulatory standards.
Disclaimer regarding services offered by third parties
• Services offered by third parties may be changed, suspended, or terminated without prior notice.
Sony does not bear any responsibility in these sorts of situations.
Waterproof and dustproof performance of the unit
The unit, with the cap fastened securely, has a waterproof specification of IPX7 as specified in "Degree of
protection against water immersion" of the IEC60529 "Ingress Protection Rating (IP Code)", and a
dustproof specification of IP6X as specified in "Degrees of protection against solid foreign objects".
• The supplied accessories and the connectors of this unit (USB) are neither water resistant nor
dustproof. To reduce the risk of fires or electric shocks, do not expose the unit to water or droplets
while using any connectors (USB) .
Note that malfunctions as a result of water immersion or dust intrusion caused by misuse by the
customer are not covered by the warranty.
To avoid the deterioration of waterproof and dustproof
performance
Carefully note the precautions below to ensure proper use of the unit.
• The unit passes the drop test from 1.22 m on plywood of 5 cm thickness conforming to MIL-STD810H
Method 516.8-Shock. However, this does not guarantee no damage, no breakdown, or waterproof and
dustproof performance in all conditions. Deformation or damage from dropping the unit or subjecting
it to mechanical shock may cause deterioration of the waterproof and dustproof performance.
• This unit does not have a design that is resistant to water pressure. Use of the unit in a location where
high water pressure is applied, such as in the shower, may cause a malfunction.
• Do not pour high-temperature water or blow hot air from a hair dryer or any other appliance on the
unit directly. Also never use the unit in a place subject to high temperatures, such as in a sauna or
near a heat source.
CAUTION : Handle the cap with care. The cap plays a very important role in maintenance of the
water resistant and dustproof performance. When using the unit, make sure that the cap is closed
completely. When closing the cap, be careful not to allow foreign objects inside. If the cap is not closed
completely the water resistant and dustproof performance may deteriorate and may cause a
malfunction of the unit as a result of water or dust particles entering the unit.
Notes on waterproof and dustproof features
(Read before using the unit)
The supplied accessories are neither waterproof nor dustproof.
Passive
radiator
Cap