Removing The Drawer - Bosch HEIP056U Use And Care Manual

To replace the oven door
1. Holding the door firmly
in both hands, grip it
on either side, not by
the handle.
2. Tilt the door back
slightly towards you
until it opens about 7"
at the top.
3. Slide the hinges into
the slots as far as they
will go and then lower
the door straight
down. The angle of
the door may need to
be adjusted slightly to
allow the hinges to
engage properly and
the door to lower into
place. The door
should lower about
3/4" and stop. If not,
the hinges have not
engaged properly and
the door could fall if it
is released.
4. Once both hinges are
fully engaged as
described in Step 3,
gently open the door
until it is fully open.
5. Push the levers on
both the hinges up
and forward until they
are locked into the
slot, flush with the
front of the oven body.
6. Close and open door
slowly to be sure it is
correctly and securely
in place.
Warming Drawer Maintenance

Removing the Drawer

9 CAUTION
To prevent burns, do not remove drawer while hot.
Be sure drawer is empty before removing.
Removing Drawer from Housing
NOTICE: The following is the manufacturer's
recommendations for removing and installing the drawer
to minimize the risk of damage to the PTO mechanism.
Remove the drawer from the drawer housing.
1.
Pull drawer to fully open position.
▯
Press down right drawer release lever.
▯
Lift up left drawer release lever.
▯
Firmly pull the drawer straight out.
▯
Retract cabinet rails while drawer is removed.
▯
2. Grasp both sides of the drawer and pulling straight
and level, carefully remove the drawer housing. This
step may require light to moderate force to completely
remove drawer.
Install or service (clean) housing with drawer removed.
3.
English 36