Timer; Care And Cleaning - Mitsubishi Electric MVZ-A12 AA4 Operation Manual

4. Timer

Timer functions are different by each remote controller.
Refer to the operation manual that comes with each remote controller for the details included an operation method.

5. Care and Cleaning

Cleaning the lters
• Clean the lters using a vacuum cleaner. If you do not have a vacuum
cleaner, tap the lters against a solid object to knock off dirt and dust.
• If the lters are especially dirty, wash them in lukewarm water. Take care
to rinse off any detergent thoroughly and allow the lters to dry completely
before putting them back into the unit.
Caution:
• Do not dry the lters in direct sunlight or by using a heat source,
such as an electric heater: this may warp them.
• Do not wash the lters in hot water (above 122 °F [50 °C]), as this
may warp them.
• Make sure that the air lters are always installed. Operating the unit
without air lters can cause malfunction.
Caution:
• Before you start cleaning, stop operation and turn OFF the power
supply.
• Indoor units are equipped with lters to remove the dust of sucked-
in air. Clean the lters using the methods shown in the following
sketches.
Filter removal
Caution:
• In removing the lter, precautions must be taken to protect your
eyes from dust. Also, if you have to climb up on a stool to do the
job, be careful not to fall.
• When the filter is removed, do not touch the metallic
parts inside the indoor unit, otherwise injury may result.
Removal and replacement of lter
• Unscrew the two thumb knobs on the panel stamped " lter" tilt forward
and pull the panel out. Grasp the edge of the lter and slide out. Re-install
in reverse. (see Fig A)
4
MVZ-A·AA4
Filter
FILTER
Fig A