Table of Contents
Advertisement
LT2000 Clone Programmer
Operation Notes
Disconnect the Clone from the TV when you are
finished; automatically switching it off. The real-
time clock continues to run after the main circuits
have been switched off.
Reset Clone After Static Shock
After replacing exhausted batteries, or if the pro-
grammer behaves strangely after a static shock,
use a paper clip or similar instrument inserted
through the small hole marked "RESET" to activate
the internal reset switch and restore normal opera-
tion.
After a reset, check the real-time clock setting. It
may be necessary to reset the Clone Programmer
clock from a TV containing the correct time.
Clone Programmer/Cloning Procedure Troubleshooting
Problem
Possible Cause(s)
Clone Programmer
LED does not blink.
• M.P.I. cord not connected.
• TV not turned on.
• Weak batteries.
Clone menu hard
• Weak signal.
to read.
No time set.
• No time on Master TV.
Menu items 7-8 not
• Not necessary.
on clone selection menu.
Master and Other TVs
Cloning did not work.
• Procedure interrupted.
• Different TV models.
Clone time disappeared.
• Batteries were removed.
Channel Labels not
• Saved to other memory.
present on cloned TV.
New Setup not present.
• TV not reset.
When cloning operations are complete, just unplug the LT2000 from the TV.
If the TV does not display a picture (blank screen) after a few seconds, just change channels.
The LT2000 programmer is designed to be used
with TVs containing the 221-01006 and later
processors. Use with earlier TV sets may give
unpredictable results. The specific microprocessor
used in any TV set may be determined by activat-
ing the Installer Menu. The microprocessor part
number appears on the screen when the Installer
Menu is activated. Processors before the 221-
01006-04 have a limited screen display capability.
They can not display entire screens as shown in
the quick setup instructions accompanying the
LT2000 clone programmer. Use the printed menu
illustrations on the quick setup sheet supplied with
the Clone as an aid to making your programming
choices. (Although the menus are not all dis-
played, the clone functions all operate normally).
Possible Solution(s)
-Connect M.P.I. cord.
-TV must be on for clone to work.
-Install 4 fresh AA high-quality alkaline
batteries.
-Connect TV to a reliable signal Source.
-Set time on master TV, copy time to
Clone Programmer.
-Channel Labels already cloned; if they
were on Master TV.
-Wait until procedure complete message
is displayed.
-Cloning is only possible with identical
model TVs.
-Batteries must remain installed to retain
time settings.
-Must save channel labels to same
memory bank as master TV setup.
-Disconnect newly cloned TV from power
for 5 seconds.
Page 53
Advertisement
Table of Contents
Troubleshooting
