Xl-hp535e micro component system consisting of xlhp535e
(main unit) and cp-hp535e (speaker system).
xl-hp535h micro component system consisting of xlhp535h
(main unit) and cp-hp535h (speaker system). (88 pages)
Page 1
Thank you for purchasing this SHARP product. To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your SHARP product. XL-HP605E Micro Component System consisting of XL-HP605E (main MICRO COMPONENT SYSTEM unit) and CP-HP605E (speaker system).
Page 2
Where plug destroyed immediately and disposed of in a safe manner. this is not possible, please visit our web-site www. sharp.co.uk/ Under no circumstances should the cut-off plug be inserted else- customersupport.
Listening to the radio ......19, 20 ! Recording and playback of any material may require consent, which SHARP is unable to give. Please refer particularly to the provisions " Tape Playback...
System connections XL-HP605E Make sure to unplug the AC power lead before any connections. Aerial connection (see page 9) FM aerial AM loop aerial Right speaker Left speaker Wall socket Speaker connection (see page 9) (AC 230 V, 50 Hz)
XL-HP605E ! Aerial connection ! Speaker connection Supplied FM aerial: Connect the black wire to the minus (-) terminal, and the red wire to Connect the FM aerial wire to the FM 75 OHMS socket and position the plus (+) terminal.
System connections (continued) XL-HP605E ! AC power connection ! Demonstration mode After checking all the connections have been made correctly, plug The first time the unit is plugged in, the the AC power lead of this unit into the wall socket. If you plug in the unit will enter the demonstration mode.
XL-HP605E(E) TINSEA028AWZZ Remote control XL-HP605E ! Battery installation Notes concerning use: " Replace the batteries if the operating distance is reduced or if the Use 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar). operation becomes erratic. " Periodically clean the transmitter on the remote control and the Batteries are not included.
General control XL-HP605E ! Volume control Main unit operation: When the VOLUME control is turned clockwise, the volume will increase. When it is turned anti-clockwise, the volume will decrease. Remote control operation: Press the VOLUME (+ or -) button to increase or decrease the volume.
Setting the clock XL-HP605E Press the button to adjust the hour and then press the MEMORY/SET button. Press the button once to advance the time by 1 hour. Hold it down to advance continuously. Press the button to adjust the minutes and then press the MEMORY/SET button.
Listening to a CD (CDs) XL-HP605E This system can also play audio CD-R and CD-RW discs, but can- ! CD playback not record. Press the ON/STAND-BY button to turn the power on. Some audio CD-R and CD-RW discs may not be playable due to the state of the disc or the device that was used for recording.
XL-HP605E ! Various CD functions " Playback will begin from track 1 on the DISC 1. After that disc fin- ishes playing, the next disc will automatically play. Function Main unit Remote Operation " After the last track on the fifth disc is played, the CD player stop control automatically.
Advanced CD playback XL-HP605E ! To specify a disc to play ! Direct track search You can play a disc by specifying the disc number. By using the direct search buttons, the desired tracks on the current disc can be played.
XL-HP605E ! Repeat play ! Random play Repeat play can play all 5 discs, all tracks on a chosen disc, or a The tracks on the disc(s) can be played in random order automatically. programmed sequence continuously. To random play all tracks on up to 5 discs: To repeat all tracks on up to 5 discs: Press the RANDOM button on the remote control.
Advanced CD Playback (continued) XL-HP605E ! Programmed play You can choose up to 32 selections for playback in the order you like. To clear the programmed selections: Press the CLEAR/DIMMER button on the re- Whilst in the stop mode, press mote control whilst the "MEMORY"...
Listening to the radio XL-HP605E ! Tuning Press the ON/STAND-BY button to turn the power on. Press the TUNER (BAND) button repeatedly to select the desired frequency band (FM or AM). Press the TUNING ( ) button to tune in to the desired station.
Page 20
Listening to the radio (continued) XL-HP605E ! Memorising a station ! To recall a memorised station You can store 40 AM and FM stations in memory and recall them at Press the PRESET ( ) button for less than 0.5 seconds to se- the push of a button.
Listening to a cassette tape XL-HP605E ! Tape playback Before playback: " For playback, use normal or low-noise tapes for the Press the ON/STAND-BY button to turn the power on. best sound. (Metal or CrO tapes are not recom- Press the TAPE button.
Main unit Remote Operation ensure that the desired material is properly recorded. control " SHARP is not liable for damage or loss of your recording arising Side A play- Press in the stop from malfunction of this unit. back mode.
XL-HP605E ! Recording from a CD (CDs) You can record the desired CD using the CD DIRECT PLAY button. Press the ON/STAND-BY button to turn the power on. Press the CD button. Load a cassette into the cassette compartment with side A facing you.
Page 24
Recording on a cassette tape (continued) XL-HP605E ! Recording from the radio Sequential recording from several CDs: 1 Perform steps 1 - 6 in "Recording from a CD (CDs)" on page 23. Tune in to the desired station (see page 19).
Timer and sleep operation XL-HP605E Timer playback: The unit turns on and plays the desired source (CD, tuner, tape) at a preset time. Timer recording: The unit turns on and starts recording from the tuner at the preset time. This unit has 2 types of timer: ONCE TIMER and DAILY TIMER.
Timer and sleep operation (continued) XL-HP605E Within 10 seconds, press the button to se- Switch input with the button, and then lect "ONCE SET" or "DAILY SET", and press the MEMORY/ press the MEMORY/SET button. SET button. To select the timer playback source: CD, TUNER or TAPE.
Page 27
XL-HP605E Checking the timer setting in the timer stand-by mode: When the preset time is reached, playback or recording will 1 Press the CLOCK/TIMER button. start. 2 Within 10 seconds, press the button to select "ONCE" or "DAILY", and press the MEMORY/SET button.
Timer and sleep operation (continued) XL-HP605E " Sleep operation To cancel the sleep operation: Press the ON/STAND-BY button whilst "SLEEP" is indicated. The radio, compact disc and cassette tape can all be turned off To cancel the sleep operation without setting the system to the automatically.
Enhancing your system XL-HP605E The connection lead is not included. Purchase a commercially avail- " Listening to the playback sounds from VCR, able lead as shown below. DVD, etc. VCR, DVD, etc. Use a connection lead to connect the VCR, DVD, etc. to the VIDEO/AUX IN sockets.
If something is wrong with this product, check the following before connected to this unit, you can enjoy sound with emphasised bass. calling your authorised SHARP dealer or service centre. Connect an RCA lead from a commercially available speaker with a built-in amplifier to the SUBWOOFER PRE-OUT socket.
Page 31
XL-HP605E ! Cassette deck ! Tuner Symptom Possible cause Symptom Possible cause " The radio makes unusual " Is the unit placed near the TV or " Cannot record. " Is the erase-prevention tab re- noises continuously. computer? moved? " Is the FM aerial or AM loop aerial "...
Maintenance XL-HP605E ! Cleaning the tape-handling parts ! Condensation " Dirty heads, capstans or pinch rollers can cause poor sound and Sudden temperature changes, storage or operation in an extremely tape jams. Clean these parts with a cotton swab moistened with humid environment may cause condensation inside the cabinet (CD commercial head/pinch roller cleaner or isopropyl alcohol.
Specifications XL-HP605E As part of our policy of continuous improvement, SHARP reserves ! Tuner the right to make design and specification changes for product Frequency range FM: 87.5 - 108.0 MHz improvement without prior notice. The performance specification fig- ures indicated are nominal values of production units. There may be AM: 522 - 1,620 kHz some deviations from these values in individual units.
3. To benefit from this guarantee, any fault which occurs must be notified to Sharp, or its appointed Service Facility within one year from the date this product was purchased. Proof of purchase must be provided.
Page 37
This file has been downloaded from: www.UsersManualGuide.com User Manual and User Guide for many equipments like mobile phones, photo cameras, monther board, monitors, software, tv, dvd, and othes.. Manual users, user manuals, user guide manual, owners manual, instruction manual, manual owner, manual owner's, manual guide, manual operation, operating manual, user's manual, operating instructions, manual operators, manual operator, manual product, documentation manual, user maintenance, brochure, user reference, pdf manual Downloaded from:...