Table of Contents
Advertisement
6.
Cannot insert
disc.
7.
Cannot eject
disc.
6-1. Check to see that the system is powered up. (The indicator
LED light will blink on pressing the eject button on the drive.)
6-2. Press eject button to check if a media is inside the drive.
6-3. Power off the drive (or PC) and then power it on again. It will
reset and allow the drive to return back to normal condition.
7-1. Check to see that the system is powered up. (The indicator
LED light will blink on pressing the eject button on the drive.)
7-2. If a media is stuck in the drive, please power off the drive (or
PC) then power on it again. Under normal condition, it will re-
set and allows normal operation of the drive to resume.
7-3. Use Emergency Eject instructions to eject a disc. Please refer
to the Using the Drive section.
7-4. If the system is capable of booting into an operating system,
attempt to issue an eject command from within the operating
system
Advertisement
Table of Contents
