Advertisement
Requirements for Ventilation
Important: The oven must be built in before it can be used.
Do not fit insulation material inside housing unit.
This would hinder the intake of air to the appliance.
To ensure adequate ventilation to the oven once installed:
- provide a ventilation opening (cut-out) of 50 mm between the back wall and the floor of the housing
unit/cabinet (see "Q" fig-1D),
- a ventilation gap of 5 mm is required between the oven top rim and the hob lower rim and
- a ventilation gap of 5 mm is required between both oven side rims and the cabinet (see fig-2B).
Important: All ventilation openings (intake and outtake) must not be closed at any time when
operating the oven.
Requirements for the housing unit / cabinet
The requirements for the heat resistance of the material used for housing unit / cabinet are as follows:
- heat resistance / Corpus : 90 °C
- heat resistance / Front : 70 °C
594
594
[fig-2C]
556
583
571
grip hole
546
21
[fig-2A]
oven
min.5
close kitchen cabinet
or appliance.
4
[fig-2B]
[fig-2D]
Advertisement
