JVC LT-40C790 Unpacking Manual

Unpacking
Guide
LT-40C790
TV
Instruction Book
& Quick Start Guide
TV Stand Neck
Accessories
Pack TV Stand Base
Fitting the Stand Neck and Base Together
1. Fit the neck onto the base.
2. Using the 4 stand base screws, screw the neck to the base.
Fitting the Stand to the TV
3. Ensure the TV is switched off and not connected to the mains power
supply.
4. Keep the protective bag on your TV, it will help to protect the TV.
Lay the TV down on a flat surface ideally on the edge of a table so the
base of the TV slightly overhangs the edge of the table, with the back
side facing up. Please make sure a soft cushioned material (such as a dry
bath towel or thick piece of foam) is placed beneath the screen.
5. Slide the stand under the lip, the neck will fit snugly over the screw
holes. Then screw the stand to the TV using the 4 stand neck screws
supplied.
• Keep the protective bag on your TV until you have attached the
stand and positioned the TV.
• The LCD display is very fragile, and must be protected at all times
when installing and removing the base stand. Be sure that no hard
or sharp object, or anything that could scratch or damage the LCD
display, comes into contact with it. DO NOT exert pressure on the
front of the TV at any time because the screen could crack.
JVC 40' LED Smart HD TV LT-40C790 Unpacking Guide.indd 1
✔
2 people are required
when unpacking your TV.
If you don't have a table
big enough, you can use
the TV box. Lie the box flat,
make sure you place the
polystyrene back in the box
first to give the box some
rigidity and strength.
LAN
SPDIF VGA
Optic.OUT
SCART
Protective
LAN
Bag
SPDIF VGA
Optic.OUT
AV IN
Cushioned
material
✘
Slide under
the lip
Table
Don't lift the TV from the top
Remove the Protective Bag
Slide under
the lip
14/12/2018 15:40