Table of Contents
Advertisement
INSTALLATION
12
Installation Place
Requirements
Before installing the appliance, check the following
information to make sure that the appliance
should be installed in a correct place.
Dimensions
A
B
C
D
E
F
Installation Location
• A grounded electrical outlet should be located
within 61 cm of either side of the appliance.
• Install the appliance on a flat floor. (Allowable
slope under the appliance: 1°)
• The floor must be level, with a maximum slope of
2.5 cm under the appliance. If the slope is
greater than 2.5 cm, the appliance cannot be
levelled properly
Dimensions (mm)
520
1500
460
1960
600
605
• Ensure that when the appliance is installed, it is
easily accessible for an engineer in the event of a
breakdown.
• Do not install the appliance in an area where it
will be exposed to water and/or weather. Failure
to follow this warning could result in risk of
electric shock, injury, or product damage or
malfunction.
• Do not install the appliance on a hollow or
flexible platform. Doing so may cause excessive
noise and vibration and result in damage or
injury if the appliance tips over.
NOTE
• A sturdy floor should support the total appliance
weight of 100 kg. The combined weight of any
other laundry appliances should also be
considered.
Recommended Installation
Spacing
The following clearances are recommended for the
appliance. Although the appliance has been tested
for clearances of 3 cm on the sides and rear,
recommended clearances should be considered
for the following reasons:
a
Allow at least 46 cm in front to open the door.
b
Allow at least 5 cm on both sides and between
the back of the appliance and the wall.
Advertisement
Table of Contents
