Daily Use - Drying Only - AEG L61472WDBI User Manual

18 www.aeg.com
10.7 Interrupting a
programme
Press Start/Pause button to interrupt a
programme which is running, the
corresponding indicator starts flashing.
Press Start/Pause button again to restart
the programme.
10.8 Cancelling a running
programme
Turn the selector dial to Off to cancel a
programme which is running. Now you
can select a new programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.9 Opening the door
When the appliance is working and
through the delay time, the door is
locked.
If, for any reason, it is necessary to open
it, firstly press button Start/Pause to set
the machine to pause.
If the indicator Door after a few minutes
goes off, the door can be opened.
If the indicator Door stays on and the
door remains locked, this means that the
appliance is already heating or that the
water level is too high. In this case the
door cannot be opened.
If you cannot open the door but you
need to open it, turn the programme dial
to Off to switch the appliance off. After a
few minutes the door can be opened
(pay attention to the water level and
temperature !) .
After closing the door, it is necessary to
set the programme and the options

11. DAILY USE - DRYING ONLY

WARNING!
Refer to Safety chapters.
again. Press button Start/Pause to start
the programme again.
10.10 At the end of the
programme
The appliance stops automatically. The
indicator of button Start/Pause, the
indicators Washing and Door go off. A
blinking will appear on the display.
If you have set a programme or an
option that ends with water in the tub,
the indicator Door remains on. The door
is locked. The water must be emptied
out before opening the door. During this
time the drum continues to turn at
regular intervals until water drain.
Follow the below instructions to empty
out the water:
• Turn the programme selector dial to
Off.
• Set the DRAIN or SPIN programme.
• Reduce the spin speed, if needed.
• Press button Start/Pause.
• When the programme has finished
the display shows a blinking
indicator Door goes off. The door can
be opened.
Turn the programme selector dial to Off
to switch the appliance off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the
door open to prevent the formation of
mildew and unpleasant smells.
10.11 Stand by
Once the programme has finished, after
a few minutes the energy saving system
will activate. The display will dim. Press
any button to deactivate the Stand By
function.
This appliance is an
automatic washer dryer.
. The