Advertisement
3．Installing/Removing the Bezel to the Server
Take the steps below to install the bezel to the server.
●Read the sections "Safety Precautions" and "Handling precautions" in the User's Guide of the
server in which you are going to install the bezel to install or remove the bezel safely and
properly.
Note: The outer dimension of NEC Express5800/T110f-E is as follows after the bezel is installed.
175.0 mm (Width) × 492.0 mm (Depth) × 367.0 mm (Height) (Projection excluded)
1. Pull the front bezel as shown in figure below, and then remove the front bezel.
2. Lift the device door as shown in figure below, and then remove the device door.
3. Install the dust proof door as shown in figure below.
Device Door
Dust Proof Door
15
Front Bezel
②
①
②
①
①
②
Advertisement
