Power Supply; Connecting To Power Sources; Installing And Removing Optional Cards; Installing A Mini-Ygdai Card - Yamaha CS-R10 Systems Setup Manual

Power Supply

Connecting to power
sources
1.
Turn off both power switches A and B on the
unit.
2.
Connect one of the supplied power cords to
AC IN connector (A), and the other to AC IN
connector (B).
3.
Connect the other end of each power cord to
an AC outlet of a different power source.
NOTE
• Follow this procedure in reverse order when disconnecting the
power cords.
• To disconnect each power cord, remove it while pressing the
latch on the plug.
WARNING
Use only the supplied AC power cords. Using other cords may
lead to overheating or electric shock.
Caution
Be sure to turn off the power to the unit before connecting or
disconnecting the power cords.
Installing and Removing
Optional Cards

Installing a Mini-YGDAI card

Before you install the card, you must check the Yamaha
Pro Audio website to see whether your CS-R10 or
CS-R10-S supports that card, and to verify the number of
other Yamaha cards or third-party cards that can be used
in conjunction with this card.
http://www.yamahaproaudio.com/
1.
Make sure that the power is turned off.
Caution
Installing or removing a card while the power is on may
lead to component failure or electric shock.
2.
Loosen the screws that fasten the slot cover,
and remove the slot cover.
Keep the cover and fixing screws in a safe place for
future use.
RIVAGE PM10 System Setup Guide
Slot cover
29