Philips HD4685/30/A Service Manual

Philips Consumer Lifestyle
Service Manual
PRODUCT INFORMATION
- Product meets the requirements regarding interference
suppression on radio and television.
- After the product has been repaired, it should function
properly and has to meet the safety requirements as laid
down officially established at this moment.
TECHNICAL INFORMATION
- Voltage
- Frequency
- Power consumption
- Contents Kettle
- Temperature setting
- Temperature indication
- Keep warm function
- Boil ready signal
- On/off indication
- Color setting
- SAP coding
DISASSEMBLY- AND RE-ASSEMBLY ADVISE
- For this type the heating element and electronics can not
be replaced!
- Disassembly Gasket.
Remove the base by unscrewing the3 Torx screws.
Open the lid and gently push (force maybe needed) on
the inside of the heater.
The heater and Gasket will move out of the Kettle body.
Remove the Gasket from the heater.
Published by Philips Consumer Lifestyle
11/10
: 220 - 240 V
: 50 - 60 Hz
: 2000 - 2400 W
: 500 - 1000 cc
: 40, 60, 80, 100 °C
: 4x LED
: 40, 60, 80, 100 °C
: Buzzer
: Light ring on/off button
: White / Steel
: HD4685/30/A
Printed in the Netherlands
- Re-assembly the gasket and heater assy.
Place the gasket on the heater assy.
(see picture for placement details.)
Make the outside of the gasket and the inside of the Kettle
housing were the gasket will be placed wet with plain water.
Gently push the heater assy with gasket equable in the
Kettle body.
While pushing inwards check if the gasket keeps well
around the heater assy.
Check visual if the gasket is correct placed.
By fi lling the kettle with plain water and leaving it for half
an hour, you can check if the gasket is properly sealing the
Kettle.
Fix the base again.
Check the functions of the Kettle.
© Copyright reserved
Kettle
HD4685/30/A
Subject to modification