Table of Contents
Advertisement
Installation
Preparing for installation
Caution!
Ensure that there are no electric wires, gas or water pipes in the
area where holes are to be made.
Mark a vertical centre line on the wall from the ceiling to the
1.
lower edge of the extractor hood.
Mark the positions for the screws and the contour of the
2.
attachment area.
Drill 8 mm Ø holes to a depth of 80 mm and press the wall
3.
plugs flush with the wall.
Screw on the fixing bracket for the flue duct.
4.
Screw in 2 securing screws with washers to approx. 5 mm.
5.
12
¨
©
Installation
Attaching and aligning the appliance.
1.
Mark the hole for the safety screw.
2.
Remove the appliance once more.
3.
ª
¨
©
ª
Advertisement
Table of Contents
