A
8
Push the end–cap back in, so
that the tabs are flush against
the end of the roll.
9
Insert the spindle with media stop (A) to the right and
end–cap (B) to the left. Push in firmly on both ends, making
sure the media remains flush against media stop (A).
The media should wind up from behind the roll.
0015
6
Rest the spindle upright on the
floor with media stop (A) at the
bottom
7
Place the new roll on the spindle,
so that the media's leading edge
winds clockwise, viewed from
above.
If the media stop (A) falls off,
push it back in until it snaps into
position.
B
1837
A
4
B
0016