Table of Contents
Advertisement
6
Base unit: To exit registration mode, press {LOCATOR}.
L Depending on the base unit, it will automatically return to standby after
registration completed.
Note:
L The AC adaptor must remain connected at all times. (It is normal for the adaptor to
feel warm during use.)
L The AC adaptor should be connected to a vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a horizontally oriented AC outlet that faces
the floor, such as an AC outlet installed on a ceiling or under a table, as the weight
of the adaptor may cause it to become disconnected.
L The unit can support a maximum of 2 handsets at a time.
L Up to 2 range extenders can be registered to the base unit.
Deregistering the range extender from the base unit
1
Unplug the AC adaptor from power outlet, then press and hold {PROGRAM}.
2
While pressing and holding {PROGRAM}, re-connect the AC adaptor.
L When the unit is in the deregistration mode, the STATUS indicator flashing red.
3
Keep pressing and holding {PROGRAM} for about 10 seconds until the
STATUS indicator light red. Then release {PROGRAM}.
L After deregistration complete, STATUS indicator and w indicator light amber for
2 seconds. Then, w indicator lights off.
Wall Mounting
Drive the screws (not supplied) into the wall. Mount the unit, then slide it down.
Note:
L Make sure that the wall is strong enough to support the weight of the unit.
4
For assistance, please visit http://shop.panasonic.com/support
Screws
37.0 mm
(1
15
/
inches)
32
Advertisement
Table of Contents
