Table of Contents
Advertisement
DAILY USE
START A PROGRAMME WITHOUT DELAY
START
1. Prepare the laundry and load the appliance.
CAUTION! Make sure that when
you close the door, the laundry
does not get caught between the
appliance door and the rubber
seal.
2. Set the correct programme and options for the
type of load.
The display shows the programme duration.
Real drying time will depend on type of
the load (quantity and composition),
the room temperature and the humidity
of your laundry after spin drying phase.
3. Press the Start/Pause touch button.
The programme starts.
STARTING THE PROGRAMME WITH DELAY
START
1. Set the correct programme and options for the
type of load.
2. Press the delay start button again and again
until the display shows the delay time you want
to set.
You can delay the start of a
programme from a minimum of 30
minutes to a maximum of 20
hours.
3. Press the Start/Pause touchpad.
The display shows the countdown of the
delay start.
When the countdown is completed, the programme
starts.
CHANGE A PROGRAMME
1. Turn the Programme knob to
2. Set the programme.
AT THE END OF THE PROGRAMME
When the programme is completed:
•
An intermittent acoustic signal operates.
•
The indicator
flashes.
•
The indicator
flashes.
•
The Start/Pause indicator is on.
The appliance continues to operate with the crease
guard phase for approximately other 30 minutes.
The crease guard phase prevents creases from
your laundry.
You can remove the laundry before the crease
guard phase is completed. We recommend, for
better results, that you remove the laundry when the
phase is almost completed.
When the crease guard phase is completed:
•
The indicator
is on but does not flash.
•
The indicator
is on but does not flash.
•
Start/Pause indicator goes off.
1. Turn the Programme knob to
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying results:
•
Inadequate default dryness level settings. See
chapter Adjustment of default dryness level
•
Room temperature is too low or too high.
Optimal room temperature is between
18°-25°C.
Always clean the filter and empty
the water container when a
programme is completed.
STAND-BY FUNCTION
To decrease the energy consumption, this function
automatically deactivates the appliance:
•
After 5 minutes if you do not start the
programme.
•
After 5 minutes from the end of the programme.
OFF
OFF
13
Advertisement
Table of Contents
