HP ProCurve J8162A Supplementary Manual page 27

Syntax: enable extended-commands
Changes the CLI to the access controller extended com­
mands context. A limited set of commands from the
720wl CLI is provided here. See "Using the ACM's
Extended CLI" for more information.
Syntax: exit
Leaves the access controller context and returns the CLI
to the global configuration context.
Syntax: [no] ip address <<ip-addr>/<1-32> | <ip addr> <mask>>
Statically configures the ip address and subnet mask
for the ACM. The no form removes the fixed ip address
and enables DHCP. (Default: DHCP)
Syntax: [no] ip default-gateway <ip-addr>
Statically configures the numeric ip-addr of the default
gateway. If DHCP is enabled, this command overrides
the default gateway supplied by DHCP.
Syntax: [no] page
Turns on or off paging of the CLI command responses
and CLI command stack replay (the up arrow func­
tion).
Syntax: terminal <length <2-1000> | width <61-1920>>
length <2-1000> Sets the number of lines that are dis­
played between pauses when page is on. The initial
setting is inherited from the previous context. This
setting remains in effect when this context is exited.
width <61-1920> Sets the maximum line width to be used
for CLI output or CLI input. Lines longer than the
specified value wrap to the next line. The initial setting
is inherited from the previous context. This setting
remains in effect when this context is exited.
Configuring the Access Controller xl Module
23