Flow control can prevent data loss from buffer overflow. When sending data, if the
receiving buffers are full, a 'stop' signal can be sent to stop the data flow. Once the
buffers are empty, a 'start' signal can be sent to re-start the flow. Hardware flow control
uses two wires to send start/stop signals.
VT-UTF8 Combo
Key Support
Enable VT-UTF8 Combination Key Support for ANSI/VT100 terminals.
Recorder Mode
With this mode enabled only text will be sent. This is to capture Terminal data.
Resolution 100x31
Enables or disables extended terminal resolution.
Putty KeyPad
Select FunctionKey and KeyPad on Putty.
Chapter 3 – AMI BIOS Setup
Enabled
Disabled
Disabled
Enabled
Disabled
Enabled
VT100
LINUX
XTERMR6
SCO
ESCN
VT400
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
29