2.3 Li st of Jumpers
Please refer to the table below for all of the board's jumpers that you can configure for
your application
Lab el
JP 4
JP 5
JP 6
JP 7
JP 9
2.3 .1
LVDS Power Select/ LVDS BKLT Power Select ( JP4)
LVDS Power Select
+5V
LVDS BKLT Power Select
1
3
5
+12V
Note: To prevent unwanted operation or damage to the system, do not connect pins in
any other configuration than what is shown.
Chapter 2 – Hardware Information
F unction
LVDS Power Select/ LVDS BKLT Power Select
LVDS Backlight Brightness Control Mode Select
Clear CMOS
AT/ATX Select
Front Panel PIN Header
2
4
6
+3.3V (Default)
1
2
3
4
5
6
+5V (Default)
11