Pack The Printer - Canon imagePROGRAF iPF825 Basic Guide No.3 Basic Manual

Preparing to Transfer the Printer

Pack the printer

1
Press the Power button and turn off the printer.
• Turn off the printer before you unplug it. It may damage the printer if you unplug it before it is off and
transfer it in that state. If you accidentally unplug the printer, plug it in again, reinstall the Ink Tank , wait
until the printer comes online, and follow this procedure again.
2
Disconnect the power cord and interface cable. Also
disconnect the power cord of the Roll Unit and Media
Take-up Unit , if your model is equipped with these units.
3
Open the Top Cover , grasp the Belt , insert it between the
Belt Stopper , and affi x the Belt Stopper with a hex screw
at the position indicated.
• Here, the Belt Stopper is the one that was removed and stored after initial installation. Neglecting to
attach the Belt Stopper may damage the printer.
4
Close the Top Cover .
6
OK