Canon Color imageCLASS MF8450c Starter Manual page 32

2 Set Up the Machine
3
Use [ ▼ ], [ ▲ ] or (Scroll Wheel) to
select<Perform Full Correction> or <Do Not
Perform Full Corr.>, then press [OK].
–
It is recommended that you select <Perform Full
Correction>.
–
It takes approximately 300 seconds to perform the full
correction.
–
For the full correction, the machine performs the
correction twice and two test prints are output by the
machine for the each correction.
You selected <Do Not Perform Full Corr.> (=Quick
●
Correction)
Make sure the following screen is displayed on the display, then press [OK] to
start the quick correction. (It takes approximately 150 seconds to perform the
quick correction.)
Recalibrations are made internally without outputting any
test prints.
After finishing the quick correction, go to "Set Up
Network Connection," on p. 32.
30
4
Make sure the following screen is displayed on
the display, then press [OK] to print the first test
page.
5
Place the first test print on the platen glass.
Place the test print face down on the platen glass, with the
black bands along the top left edge of the platen glass.
Stack approximately 20 sheets of blank paper on top of the
test print for a more precise gradation correction.
6
Make sure the following screen is displayed on
the display, then press
correction.
7
Remove the first test print from the platen glass.
(Start) to perform the