HP Compaq Presario,Presario S3000 Installation Manual page 9

Resetting ID Buttons
When Replacing Batteries
When the batteries are replaced in the mouse,
reset the ID buttons on the receiver and the
mouse to allow the mouse to work with the
receiver. You must press the receiver ID button
first and then press the mouse ID button. Refer
to the steps in the section "Setting Up the
Wireless Set."
Note: You can replace the batteries in the mouse
without turning off the computer. However,
the computer must be on when you change
the ID settings.
Using the Wireless Set
The blue light (J) on the receiver (D) indicates
activity when you move or click any button on the
mouse. The button (E) is the receiver ID button.
Use the receiver on a nonmetallic surface for
better reception.
D E
The optical mouse uses a light to sense
movement. Use the optical mouse on an opaque
surface; the optical mouse cannot work on a
glass, translucent, or reflective surface.
Installing the Optical Wireless Mouse Set
J
7