HP Pavilion 900 CTO Quick Start Manual page 57

Locate the RJ-45 port on the back of the
computer. (Refer to the illustration that matches
your system.)
RJ-45 port
To connect the network interface adapter to the
network:
1 Plug the network cable into the RJ-45 port on
the network adapter. The port is located on
the back of the computer.
Note:
Do not connect a telephone cable (RJ-11
connector) to the network adapter port (RJ-45).
2 Plug the other end of the network cable into a
10BaseT or a 100BaseT port on the
network hub.
Note:
The hub is a device to which all computers on
the network are connected.
Warning:
DO NOT plug the network
cable into a telephone jack.
3 With the computer turned on, check the
light-emitting diodes (LEDs) on the network
adapter. The LEDs on each type of network
adapter are described below. (Refer to the
illustration that matches your system.)
LEDs
10 LNK — Lit green when connected to a
3
10BaseT port
100 LNK — Lit green when connected to
3
a 100BaseT port
ACT — Lit during network data transfer
3
activity
35
Quick Start Guide