Sealey LED16S Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMP P OR R TA TANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
TH H E P P RO O DUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PE E RS S ON N AL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY

Maintain the light in good condition.

Ensure the light is installed correctly in accordance with these instructions.

Only install the light on a vertical surface.

DO NOT fi x the light on any horizontal surface i.e. ceiling, or overhang.

Install away from fl ammable or combustible materials.

DO NOT direct the light into a persons eyes.

DO NOT install the light where it is likely to be knocked or hit.

DO NOT install in bathrooms, shower rooms, sauna or such locations.

DO NOT install near an exhaust outlet. e.g. Boiler fl ue, dryer outlet etc, or mirrored surfaces.

DO NOT put the light in an area that is well lit at night, e.g., near a street light. This may stop the sensor from determining when it
is night time and will stop the light from operating.

The light must be securely fi xed to the mounting surface. The screws and wall plugs supplied are suitable for masonry only.

Mount the light level and horizontal to the ground.

Turn the light off if it is not to be used for long periods.

Locate the light away from obstructions that block the light from reaching the solar panel such as overhanging tree branches,
fences or buildings.
2. INTRODUCTION
16W Extra slim solar fl oodlight with wall bracket. 14 SMD LED producing 1600 lumens featuring both daylight (CIR) and motion
(PIR) sensors to switch on automatically. Motion sensor can detect up to 5 Metres. Mounted in die-cast powder coated aluminium
extra slim housing with wall bracket. Containing one 3.7V Li-ion battery capable of a run time of 10 hours and has a 30
second timer upon sensing motion.
3. SPECIFICATION
Model No: .................................................................LED16S
IP Rating: ........................................................................IP65
LED Type: ................................................................. 14 SMD
Lumen Output: .......................................................... 1600Lm
Operating Time:
............. 10 hours, 30 seconds once motion sensor activated.
PIR Motion Sensor: .......................................................... Yes
Power: .............................................................................16W
Supply: ...............................................................................5V
4. ASSEMBLY
4.1. INSTALLATION
Unpack the product and check contents. Should there be any damaged or missing parts contact your supplier immediately.
Give careful consideration to the position of unit to ensure you obtain maximum benefit from the lighting range.
4.1.1. With care remove the wall bracket from the light assembly by unscrewing the retaining thumb screws (fi g 1).
4.1.2. Locate the thumb screws, solar panel and light in a secure location.
4.1.3. Place the wall bracket at your desired location and spot mark through the slots onto the fi xing surface (fi g 2).
4.1.4. Secure wall bracket with appropriate fi xings, wall plugs, to suit mounting surface.
4.1.5. Reassemble the light assembly (fi g 3).

WARNING! If working at height take adequate safety precautions to prevent injury from falling.
© Jack Sealey Limited
16W SMD EXTRA SLIM SOLAR FLOODLIGHT
WITH WALL BRACKET
LED16S
MODEL NO:
Original Language Version LED16S Issue 1 07/03/22