HP Vectra VE5 4 Installation Manual page 31

Windows NT Requirements
Workstation
• HP Vectra with Microsoft Windows NT Workstation 3.51 installed.
Version 3.51
• 3COM Etherlink 3C509-B ethernet card and drivers disk ver. 5.0.Driver
• Microsoft Windows NT Workstation 3.51 and Service Pack Media.
• Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/
Device Configuration
• I/O Base Address
• Interrupt Request Level
• Boot PROM
• Transceiver Type
• Network Driver Optimization
• Maximum Modem Speed
• Plug and Play Compatibility
• Full Duple
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink III 3C509-B
2 Connect network cable media to the 3COM 3C509B card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the 3COM Software "3C509-B Ethernet drivers disk
5 Select "CONFIGURE NIC" and verify the resource settings listed above
6 If changes are required, save those changes and exit.
7 Remove the 3com software driver diskette and reboot the machine.
8 After windows loads, open the "Main" program group, double-click on
Name: Elnk3.SYS Size: 27KB Date: 7/18/96
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
adapter card into an ISA slot.
ver 5.0." and execute "A:\3C5X9CFG.EXE."
under the heading "Device Configuration."
"Control Panel" icon.
4 Connecting to a Windows NT Server 4.0
Windows NT Workstation Version 3.51
300h
10
Disabled
Auto Select
Windows or OS/2 Client
9600 Baud
Disabled
Disabled