Table of Contents
Advertisement
EMU40982
Power trim and tilt unit will not operate
EWM02330
WARNING
Never get under the engine while it is tilt-
ed. Severe injury could occur if the out-
board motor accidentally falls.
If the outboard motor cannot be tilted up or
down using the power trim and tilt unit be-
cause of a discharged battery or a failure with
the power trim and tilt unit, the outboard motor
can be tilted manually.
1.
Stop the engine.
2.
Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
1. Manual valve screw
3.
Tilt the outboard motor up manually to the
desired position, and then tighten the
manual valve screw by turning it clock-
wise.
EMU44520
Water separator-alert indicator blinks
while cruising
EWM02542
WARNING
Gasoline is highly flammable, and its va-
pors are flammable and explosive.
Do not perform this procedure on a hot
●
or running engine. Allow the engine to
cool.
Trouble Recovery
There will be fuel in the fuel filter. Keep
●
away from sparks, cigarettes, flames or
other sources of ignition.
Some fuel will spill during this proce-
●
dure. Catch the fuel in a rag. Wipe up any
spilled fuel immediately.
The fuel filter must be reassembled
●
carefully with the O-ring and filter cup in
place. Improper assembly or replace-
ment could result in a fuel leak, which
could result in a fire or explosion hazard.
If the water separator-alert indicator blinks,
perform the following procedure.
1.
Stop the engine.
2.
Remove the top cowling.
3.
Disconnect the water detection switch
coupler. NOTICE: Be careful not to get
any water on the water detection
switch coupler, otherwise a malfunc-
tion could occur.
1. Water detection switch coupler
4.
Remove the filter cup from the filter hous-
ing, and then remove the O-ring from the
filter cup. NOTICE: Be careful not to
twist the water detection switch lead
when unscrewing the filter cup.
[ECM01950]
1
ZMU07789
[ECM01960]
91
Advertisement
Table of Contents
