Dvd Does Not Play Or An Error Appears On Screen - HP z560 Setup Manual

DVD does not play or an error appears on screen

Content-protected commercial DVD playback requires 480i or 480p format settings when component video is
connected. This applies to most retail movie DVDs. DVDs may not play after your TV/display settings are
optimized because of copy protection that is built into commercial DVDs.
Problem: You might see a blank screen or an error message indicating that your DVD will not play, after you
insert it into the drive and select play.
Solution: To play a commercial DVD video, in component video, in Media Center, if you see an error message
or blank screen:
1 Press Stop on the remote control.
2 Press Media Center on the remote control or keyboard.
3 Click More Programs, HP Settings, and then Video Settings.
4 Do one of the following:
•
Click DVD Mode (480p). (Select this mode only if your TV supports 480p mode.)
Or
•
Click Display/Connection Wizard. Follow the onscreen instructions to set the 480i format. The screen
may flash as the settings are applied.
NOTE: Select 480p mode only if your TV supports 480p progressive scan mode. If your TV does not support
480p mode, set 480i mode and play the DVD.
5 Press Media Center on the remote control or keyboard.
6 Click Play DVD.
7 After playing the commercial DVD video in component video, use the TV/Display Setup Wizard to return the
desktop image and Media Center to a higher-resolution format. See "TV/Display Setup Wizard" on page 5.
Follow the onscreen instructions.
HP Digital Entertainment Center TV/Display Setup Guide
23