Table of Contents
Advertisement
a.
The customer agrees to use only HP Branded Consumables and HP Certified Materials in the 3D HP
printer product, and understands that use of any consumables other than HP consumables may cause
serious product functionality and/or safety issues, including, but not limited to, those outlined in the
user guide. The customer agrees not to use the product and/or consumables for uses not permitted by
US, EU, and/or other applicable law.
b.
The customer agrees not to use the product and/or consumables for the development, design,
manufacture, or production of nuclear weapons, missiles, chemical or biological weapons, and/or
explosives of any kind.
c.
The customer agrees to comply with the connectivity requirement outlined below.
d.
The customer may use firmware embedded in the product only to enable the product to function in
accordance with its published specifications.
e.
The customer agrees to comply with the user guide.
f.
Products, services, and/or technical data provided under these terms are for the customer's internal use
and not intended for further resale.
3.
Dynamic security enabled printer. Only intended to be used with cartridges using an HP original chip.
Cartridges using a non-HP chip may not work, and those that work today may not work in the future. More
at: http://www.hp.com/go/learnaboutsupplies.
4.
If product failure or damage is attributable to the use of a non-HP and non-HP-approved consumable
product, HP will charge its standard time and materials charges to service the printer for the particular failure
or damage.
5.
Responsible use of 3D printing
Customer represents, warrants, and agrees that it has and will exercise appropriate policies to ensure that all
digital files printed on the Product may legally be 3D printed on the Product in accordance with US and other
applicable laws. Customer further represents, warrants, and agrees that, if the digital file is for a firearm,
Customer shall ensure:
a.
The end user of the resulting firearm 3D Printed Part is a licensed and regulated firearms manufacturer.
b.
The resulting firearm 3D Printed Part is detectable by airport or similar weapons security screening
technology in accordance with US and other applicable laws.
c.
The resulting firearm 3D Printed Part will be traceable by US and other applicable law enforcement.
Customer agrees that HP may require Customer to periodically certify that Customer is in compliance with
this "Responsible Use" provision. In addition to other remedies available at law or in equity, HP reserves the
right to disable the Product and/or stop selling consumables and service if HP determines that Customer
has violated this provision. For the purposes of this Section 5, "3D Printed Parts" means any output or parts
created, developed and/or produced by Customer or its customers, partners, and/or other end-users from
use of the 3D printing system and consumables.
6.
Connectivity requirement and remote monitoring
a.
The customer will allow HP to install the HP Command Center software (or other applicable HP software
that controls the HP product and enables remote monitoring) on the customer's computer.
b.
The customer will keep that computer connected to the HP product, and the customer will keep the HP
Command Center software running on that computer and connected to the HP product at all times.
14
Chapter 6 Other terms and conditions
Advertisement
Table of Contents
